
2. Slowly lift the drawer.
3.
Pull the drawer out fully.
To install the drawer, do the above steps in
the opposite sequence.
Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
WARNING! Danger of
electrocution! Disconnect the
fuse before you replace the
lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2.
Clean the glass cover.
3.
Replace the lamp with a halogen, 230
V, 40 W, 300 °C heat resistant lamp.
4.
Install the glass cover.
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
What to do if...
Problem Possible cause Remedy
You cannot activate the ap-
pliance.
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
You cannot activate or oper-
ate the hob.
The oven does not heat up.
The fuse is released. Make sure that the fuse is the
cause of the malfunction. If
the fuse releases again and
again, contact a qualified
electrician.
You cannot activate or oper-
ate the hob.
The fuse is released. Activate the hob again and
set the heat setting in less
than 10 seconds.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation set-
tle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
15
Comentários a estes Manuais